RHUB TM-510 Specifikace stáhnout pdf (Strana 266)

100

101

10-6

TM 9-2350-311-34-1

10-1 WINTERIZATION KIT INSTALLATION — CONTINUED

a Installation — Continued

Place

four batteries on two battery trays with battery terminals positioned as shown below. Secure batteries

using mounting components (TM 9-2350-311-20-1).

Open transmission left and right access doors and air-intake grille. Install four shock mounts (19) and two

coolant heater mounting brackets (20) to hull front plate (21) with four lockwashers (22) and four nuts (23).

Cut 3.5 in. (8.9 cm) out of existing engine inlet coolant hose (24) at point midway between two coolant heater

mounting brackets (20). Discard hose section. Place two clamps (25) over two hose ends, insert “Y” tube (26)

as shown below, and tighten clamps.

Place

hose clamp (27) over end of 0.625-in. - (15.9-mm-) id by 16-in. - (40.6-cm-) long hose (28). Install hose to

"Y" tube (26) and tighten clamp

1 2 ... 261 262 263 264 265 266 267 268 269 270 271 ... 352 353

Komentáře k této Příručce

Žádné komentáře

RHUB TM-510 Specifikace Strana 266

Komentáře k této Příručce